Plankton + Rhinocommon Version

Hello,

I am trying to test a definition using the Plankton plug-in for re-meshing. I have changed the referenced paths of the assemblies, but the C# component still doesn't run. It keeps having error with the Rhinocommon version...

I have downloaded the latest version of Rhinocommon, but still the same...Any help?

Thnx in advance

Replies to This Discussion

Permalink Reply by Arend on May 5, 2014 at 8:41am

Are you sure you're at the latest/recent rhino service release? It's complaining about an old RhinoCommon version.

Permalink Reply by Catherine Sara on May 5, 2014 at 11:09am

I downloaded from this page:

http://www.rhino3d.com/download/rhino/5.0/RhinoCommonSdk

Permalink Reply by Daniel Piker on May 5, 2014 at 12:01pm

Hi Catherine,

that's the link to download the SDK, which isn't necessary to use Plankton. This problem is more likely to be caused by a missing service release, as Arend points out (from Rhino's Help menu choose 'Check for Updates')

Permalink Reply by Catherine Sara on May 5, 2014 at 1:47pm

Thanks a lot,

it was the Rhino release indeed, it finally run when updated to Rhino 5 SR8

Thnks again, nice work!!

RSS