algorithmic modeling for Rhino
Tags:
Hi Eugene,
how do you know which planes are neighbouring?
--
David Rutten
david@mcneel.com
Seattle, WA
Hi David.
I have a control (input) points on XY-plane they are projected onto (input) surface, and there they make new planes all according to input surface normals. Then i have a list of planes.
So the neighbour definition should go from my input points (maybe through Voronoi???).
And i am pretty confused as i seem to find no possibilities to intersect them with each other.
I tried extracting list into many with "cull", it had no effect.
Tried "BRep", but it needs two or three planes (where i have close to a 100).
I imagine the end resuls like Voronoi pattern with only difference that all generated surfaces must be planar.
And that's how i want them to look like (only without these jumpy edges -made with 3d voronoi- not exactly the result i search for).
Thank you for your time.
Best regards.
Eugene.
Hello Eugene,
Did you find a solution ? I have exactly the same problem
This could be a start.
Hope this helps!
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by