Grasshopper

algorithmic modeling for Rhino

Picking the adjacent surfaces..

Hey all :-)

 

I need to pick the adjacent surfaces and put the same surfaces into the same branch structure..

I've tried using brep explode and counting common vertices, but without success..

any ideas?

See file and pic. :-) 

 


Uploaded with ImageShack.us

Views: 658

Attachments:

Replies to This Discussion

Permalink Reply by Mateusz Zwierzycki on April 15, 2013 at 5:57pm

http://www.grasshopper3d.com/group/milkbox/forum/topics/mesh-pipe-a...

after converting theses surfaces into mesh, you can use merge mesh component.

Permalink Reply by Thomas Perkov on April 16, 2013 at 1:28am

Hey Mateusz

I can't get it to work without flattening the B input.. And the output then it don't give any branches and it gives all four faces as output.. 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service