Grasshopper

algorithmic modeling for Rhino

picking and choosing from geometry list (based on a boolean list)

Hi!

i have two lists. one has boolean variables, the other has points. i want to pass on to a following component only the points that have the same position in their list as the True components in the boolean list. How could i do this?

thanks !

Views: 447

Replies to This Discussion

Permalink Reply by Pep Tornabell on December 27, 2009 at 10:05am
The cull pattern component should do the job. Input the list of points and the boolean list as pattern. Hope it helps

Pep
Permalink Reply by Andrei Raducanu on December 27, 2009 at 10:57am
did the job, thanks!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service