Grasshopper

algorithmic modeling for Rhino

Phylogenic curves

Hello, I'm new in Grasshopper, I ve been studying the auditorium park in barcelona from foa: in gh i ve managed to create a field of parallel curves, but i was wondering if there was a geometrical way to create from ellipses, not using force fields, patterns like the| attachement. 

thank you!

Views: 391

Attachments:

Replies to This Discussion

Permalink Reply by mark zirinsky on August 13, 2017 at 7:29am

here are some of the grasshopper components for creating ellipses. The trick is to calculate the base geometry needed.

Permalink Reply by F L on August 13, 2017 at 8:57am

Thank you mark! however, I was wondering after creating the ellipse if there was a controlled way to alter the"control points" of the parallel curves like the attachement below.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service