Grasshopper

algorithmic modeling for Rhino

Perform Loft between quadrants

Hey everyone!

I was trying to perform a loft in the following wireframe structure (image) but had no luck.

I would like to create a single loft to then divide in multiple surfaces according to the quadrants so I can extrude each one of them with different heights.

or

I would like to create a loft or a "patch" in each quadrant separatedly so i can end with surfaces and  then perform the operation detailed above (extrusion).

I tried with network surface, surface from points and had no luck

ALL SUGGESTIONS ARE APPRECIATED

thanks, federico

argentina.

Views: 391

Attachments:

Replies to This Discussion

Permalink Reply by fedezorrozuag on April 8, 2017 at 5:25pm

I've just uploaded a symplified version of the file shown in picture

Permalink Reply by Hyungsoo Kim on April 9, 2017 at 12:43am

In my opinion, "Loft' is enough for what you want to accomplish.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service