Grasshopper

algorithmic modeling for Rhino

Perforated Surface

Hi guys,

I'm trying to get a perforated surface with circles of the same diameter,

I've tried to loft the a surface in between the circles and the containing rectangle but it doesn't work.

I'm sure it's very simple, could anyone guide me on this?

Many thanks

Stephanie

Views: 1845

Replies to This Discussion

Permalink Reply by Dedackelzucht on March 1, 2013 at 2:05am

Best Regards

DeDackel

Permalink Reply by STEPHANIE CHALTIEL on March 1, 2013 at 2:39am

Thanks a lot, Could you please send me the gh definition. Please see attached mine. I need to be able to select the curves that will form the surface.

many thanks

Stephanie

Attachments:
Permalink Reply by STEPHANIE CHALTIEL on March 1, 2013 at 2:55am

Hi DeDackel again,

I've just did that definition, please see attached, but it doesn't work for what I'm trying to achieve.

Please see attached the image of the geometry I would like to vary.

many thanks

Attachments:
Permalink Reply by Dedackelzucht on March 1, 2013 at 5:19am

Flatten the input of the last Component is the trick

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service