algorithmic modeling for Rhino
Perfomance problems with simple loft
I've made simple loft between two curves. It takes ~5min and almost 8gb of ram. What did go wrong? If i do it in rhino, it will works good, but if i add this surfaces to grasshopper it will slow anyway.
Views: 332
- Attachments:
Replies to This Discussion
-
Permalink Reply by Danny Boyes on
-
It doesn't take that long for me.
The only thing I can suggest is move the model closer to the Origin and see it takes as long.
Maybe your Mesh settings in GH are set too high for Quality
-
-
Permalink Reply by Doublemaster on
-
Thank you. I will reistall grasshopper.
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Diamond Ring
Added by Parametric House 0 Comments 0 Likes
-
Contour Roof
Added by Parametric House 0 Comments 0 Likes
-
Tangent Arcs
Added by Parametric House 1 Comment 0 Likes
© 2024 Created by Scott Davidson.
Powered by
