Pattern

Replies to This Discussion

Permalink Reply by Jay Dhorajiya on November 9, 2017 at 1:24am

Permalink Reply by Arwed Gollner on November 9, 2017 at 6:31am

Hi there.

You could do the following.:

1. Load picture into photoshop. remove the perspective distortion

2. load the "flattened" pic into a vector drawing program or CAD program of you choice

3. redraw with paths or curves in the area of one pattern tile

4. use those curves in Grasshopper to repeat the tile..

voila 

Permalink Reply by Jay Dhorajiya on November 9, 2017 at 11:22am

Hi there,

Thank you for your response, I did followed your procedure and i haven't got the satisfactory results.  

i am looking for a scripted method which will help me to achieve and control the number of slots created, i need some sort of scripted base method where i draw the main curves and rest it grows on itself. 

Then later i can also offset to create thickness and achieve those slots. 

can you please guide me to achieve this results as shown in early images.

Thanks & regards, 

 

Permalink Reply by Jay Dhorajiya on November 9, 2017 at 11:57am

To be precise i need fractals along the curve. 

Will be waiting for your reply

Thanks.