Grasshopper

algorithmic modeling for Rhino

Parametric Wall - Under Construction

I am working on a parametric wall, 

I was asked couple of times how I did a definition I posted long time ago

https://naeimdesigntechnologies.wordpress.com/2013/10/03/brick-wall...

I forget how I did it, and couldn't find the file 

so I tried to rebuild it, but this time with Anemone

resulted definition is a bit different

I still got few collisions, and I will try to fix it soon 

if you have any recommendation please let me know

It's slow and boring 

Just press red loop starter and wait for a minute

Views: 594

Attachments:

Replies to This Discussion

Permalink Reply by Mohamed Naeim on November 20, 2016 at 11:56am

This file is for the first image 

Attachments:
Permalink Reply by Mohamed Naeim on November 20, 2016 at 12:06pm

doesn't know why it had few colliding points, 

I am too exhausted to look at it again today

I will try again tomorrow


RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service