Grasshopper

algorithmic modeling for Rhino

Parametric curve

I didn't found possibility of defining the curve as: x(t); y(t) z(t).
Some solution is to define like this a set of points and then interpolate it.
Would it be the only solution?
In my case x, y, z (t) are based on sin and cos (curved 3D spirals) so it was much simpler the direct definition than interpolation... 

Views: 1106

Replies to This Discussion

Permalink Reply by David Rutten on June 22, 2016 at 3:58am

Hi Janusz,

see this thread about various types of curve expressions.

Permalink Reply by Janusz Kozlowski on June 24, 2016 at 2:52pm

Thanks, was very useful!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service