Parallel Curves

Hi, I've been trying to set up a series of curves that are parallel to each other. I started with a sine curve lined up to an endpoint of a line. Using the divide component I was able to repeat the sine curve. Is there a better way to do this with more flexible curves? Also, the curves decrease in size as they are repeated and I would like to try keeping them the same size. Any advice appreciated. Thanks!

-Bill

Parallellines_3.ghx

Replies to This Discussion

Permalink Reply by Dedackelzucht on March 29, 2011 at 1:26am

I am not sure what you are looking for? Maybe that helps, or you could explain it with a sketch?

Attachments:

Parallellines_3_Dackel.ghx, 166 KB

Permalink Reply by bill b on April 2, 2011 at 9:07pm

Thanks again Dedackelzucht!

That's kind of what I'm getting at. I'd like to take the sine curve and repeat it along the series of lines. I played around with it a little bit, but haven't been able to get the result I want. With Grasshopper I'm trying to get what is shown in the Right View window of the attached Rhino file.

-Bill

Attachments: