Grasshopper

algorithmic modeling for Rhino

Panneling on a trimmed surface/problem

Hi all,

I' am new to gh so probably my problem has an easy solution for you.I want to panel a trimmed surface, but when i bake, the solution panels the surface in its untrimmed condition.I get that the problem is caused by the fact that the control points of the surface are still there and "confuse" gh, but i have no idea of how i can fix the problem. Any suggestions??

Thank you in advance,

George

P.S. I attach a screnshot which shows the problem and a screenshot of the definition

Views: 3284

Replies to This Discussion

Permalink Reply by Apostol Răzvan Florin on October 24, 2012 at 8:44am

need an answer to this too :(

Permalink Reply by Rajaa Issa on October 24, 2012 at 9:33am

The best way to deal with trimmed surfaces is to avoid creating one if you can help it.

Was the surface created in Rhino?  Maybe you can try to "shrink" the surface before feeding it into your logic?

Permalink Reply by djordje on October 24, 2012 at 10:13am
Permalink Reply by George Manousis on October 24, 2012 at 11:41am

Thank you for your help djordje, problem solved!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service