Paneling MisConception

Hi all,

I just wanted to make a pattern for one surface i'd created. the definition based upon Islamic Geometry and panel has been created by point intersections. the problem is when i want to operate the panel to the surface the adaptation won't be compromise as it should be, i cana find out why it gets complicated. can any one check out the files attached below?

regards

Attachments:

base surface.3dm, 61 KB
pattern.gh, 26 KB

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on February 12, 2013 at 12:43pm

Mahdi, Check the attached files...

Attachments:

basesurface_msr.3dm, 205 KB
pattern_msr.gh, 37 KB

Permalink Reply by Mahdi Soheyli Fard on February 12, 2013 at 12:55pm

Sorry Bro,

by all means from huge real thanks,

i know it's disgusting but, would you mind plz saving these files for Rhinoceros 4.0?!!! and Grasshopper 0.9 actually!

Permalink Reply by Mostapha Sadeghipour Roudsari on February 12, 2013 at 5:51pm

sorry to get back to you late. I don't know how can I save down a Grasshopper file...

I captured what you need to do. You need to Graft the input surfaces, remove the Flatten, and use Path Mapper. Path Mapper will be different if you want to use the script for one surface or multiple surfaces.