Pairing set of curves to another set of curves

Dear GH community,

I wish to pair two lines, the beam line (red) and vector line (green). Currently the supposedly paired lines doesn't share the same path number and far way don't match. I want to achieve what is in below image. I hope somebody can figure it out for me and I will be in gratitude.

Thanks and regards,

Homar

Attachments:

SORT VECTOR_member_TEST.gh, 94 KB

Replies to This Discussion

Permalink Reply by Daniel González Abalde on June 15, 2015 at 6:00am

Hi Homar, here you have it.

But you have more vector lines that beam lines, so I split the vector lines list. I hope you serve.

Attachments:

SORTVECTOR_member_TEST.gh, 180 KB

Permalink Reply by Homar on June 15, 2015 at 6:09am

It perfectly serves my purpose!!! Thank you Daniel.

Regards,

Homar

Permalink Reply by FRiou on June 15, 2015 at 6:10am

Hello Homar,

Here is my method.

Unlike Daniel, I have the same number of vectors and beams.

Attachments:

SORTVECTOR_member_TEST bis.gh, 97 KB

Permalink Reply by Homar on June 15, 2015 at 6:16am

Yes Friou. Your solution is also great. Thanks.

Permalink Reply by Raul Matagringo on June 15, 2015 at 6:12am

hi,

how about "Curve Nearest Object" component.

Permalink Reply by Homar on June 15, 2015 at 6:21am

Yours is the most compact definition. Thanks.

Permalink Reply by Daniel González Abalde on June 15, 2015 at 6:27am

Less components but more time of execution, surely because this method use a algorithm to get the closest points of the curves, instead my method use the center point, wich in this case could be used.

Permalink Reply by Homar on June 15, 2015 at 6:35am

Correct Daniel, your definition is faster and I will be using it for my work. This is just one set of line pairing and I need to pair more so I need your efficient definition.

Thanks again.

RSS