Grasshopper

algorithmic modeling for Rhino

Packing geometry inside of geometry

Hello all,

I was wondering what the easiest way to pack geometry inside of a geometry so that nothing goes outside of the bounding geomethry.  Say I have a cylinder, and want to fill it full of truncated octahedrons.  The size of the internal geometry would be the same all the way through but I'd like to have the ability to customize it (say spheres or cubes) and change the bounding geometry to say a blob.  I've attached a gh of my start... would I need something like Kangaroo? 

Thanks for any help!

Views: 1420

Attachments:

Replies to This Discussion

Permalink Reply by taz on September 11, 2015 at 11:09am

From previous discussions 3D nesting is a bit of a tough nut to crack...

You could use Pack Rat but I think it only works with rectangular objects.

Permalink Reply by Ethan Gross on September 11, 2015 at 3:09pm

Jon, since truncated octahedra are space-filling, I constructed a 3d array of them and then picked all those that were within the cylinder. Have a look.

Permalink Reply by Jon on September 11, 2015 at 6:33pm

I've been trying an array of the shape and then cull out those outside of the shape... did you mean to attach something?

Permalink Reply by Ethan Gross on September 11, 2015 at 6:49pm

Sorry. Hope it appears now....

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service