Grasshopper

algorithmic modeling for Rhino

>Orient: 2 points< in Grasshopper

I have my geometry - I have 2 curves I have subdivided - I want to orient >Copy NoScale< my geometry along those 2 curves per the 2 starting points in the geometry to the list of points on the 2 curves. I have had no success so far. Array along curve does not give the control I need.

Any thoughts? I feel like I am overlooking something simple here.

TIA

Robb

Views: 1064

Replies to This Discussion

Permalink Reply by Vongsawat Wongkijjalerd on November 28, 2016 at 10:43pm

I think you're looking for [Orient Direction]
(though you can also use [Orient] if you prefer working with planes over vectors)

the Unit Vector is in there to stop it from scaling.

Also, pictures or a gh file is usually helpful when asking for help, had to read that a couple of times to figure out what you wanted.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service