Grasshopper

algorithmic modeling for Rhino

optimization problem

hi everybody

I'm optimizing Daylight Autonomy and PMV comfort and my parameters are angle and the width of louvers. At some months like December,January,February it doesn't show any results for optimization and it doesn't show any red cubes at the screen .I mean the optimization runs successfully for other months but  I don't know where the problem is. Is it possible that octopus doesn't show anything for maximizing DA and PMV comfort?

Can anyone help me? I'll appreciate it

tnx

Views: 466

Replies to This Discussion

Permalink Reply by Ahmed Toutou on September 19, 2017 at 12:33

Hi, Leila:
I am working on MOO via Octopus also.
Can you upload your gh file to check it?

Permalink Reply by Ahmed Toutou on September 19, 2017 at 12:35

I faced many problems before while working in Octopus
i may found your problem 

Permalink Reply by leila pasandi on September 19, 2017 at 14:13

hi Ahmed

you mean that you could fix all of them? I think my problem is kind of weird.. 

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service