Grasshopper

algorithmic modeling for Rhino

Open & close grasshopper using matlab

Hi all,

Currently I am trying to find a way to open and close grasshopper from Matlab, perhaps through dos command.

Can matlab somehow interact with grasshopper in this way?

Would there be a direct command from matlab or have to be done through dos?

Thank you very much in advance. 

Views: 241

Replies to This Discussion

Permalink Reply by Earth on May 5, 2015 at 6:12am

Currently I link grasshopper with matlab through csv file. 

But I need to be able to open and close Rhino and Grasshopper from matlab for optimization purpose that is done in matlab. 

Any advise would be much appreciated.

Thank you alot again in advance.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service