Grasshopper

algorithmic modeling for Rhino

offsetting curves and move to different heights

Hi all,

 

I have been trying to make a surface out of several offset curves from a base curve from simple manipulations of offsetting distances. After that, I am trying to put these curves each into a new height away from the basecurve. Somehow the simple move component in GH moves all of the curves to the same height instead of moving them each individually.

 

I feel like this should be a very simple solution, anybody knows the solution to it please help!!

 

Here is how it looks

 

Thanks everyone!

Views: 1616

Attachments:

Replies to This Discussion

Permalink Reply by Chris Tietjen on March 10, 2011 at 4:52pm

Can you post your definition file?

 

Chris

Permalink Reply by Fan Zhang on March 10, 2011 at 5:10pm

yep here it is..

 

I think I found the solution by flattening the list of offset curves. and then send them to move.

 

However there seem to be a line of seam in the lofted surface that I can't get rid of. Is this common for lofted surface in GH?

 

Attachments:
Permalink Reply by Chris Tietjen on March 10, 2011 at 5:40pm

You can attach a Mesh Brep component to the output of your loft and then turn off preview in the loft component.  Nice definition by the way.

 

Chris

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service