Grasshopper

algorithmic modeling for Rhino

offset problem voronoi

hi,

i'm still really new into grasshopper.

as you can see i've a offset problem in my grasshopper file. in every second triangle it reverse the offset in the wrong direction i think. so i can't fillet the curves and they intersect.

what can i do to against this problem?

thx

Views: 1588

Attachments:

Replies to This Discussion

Permalink Reply by Danny Boyes on May 23, 2014 at 7:17am

A common solution is to offset in both directions and cull the unwanted larger curve

Permalink Reply by horstmith on May 23, 2014 at 8:28am

thank you!

the offset work, but i don't understand the cull option. what i've to do? which cull option dose i need? 

thx

Permalink Reply by Danny Boyes on May 23, 2014 at 8:57am

Something like this:

Permalink Reply by horstmith on May 23, 2014 at 9:15am

wow!
thank you!

Permalink Reply by horstmith on May 23, 2014 at 1:43pm

i'm sorry to annoy you all again, but her is my next problem :(

i tried a lot, but i can't solve the problem. how can i trim the sections from the big curves,
and how can i fillet them like the others?

thx a lot!

Attachments:
Permalink Reply by horstmith on May 23, 2014 at 2:54pm

problem solved :)

but how can i reduce the time from the trim battery?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service