Grasshopper

algorithmic modeling for Rhino

Offset problem

I would like to offset some lines based on the given planes, but I don't know why there are something wrong with the offset component? could someone tell me Where am I wrong?

Views: 253

Attachments:

Replies to This Discussion

Permalink Reply by Ola Jaensson on April 20, 2014 at 9:08am

You have a lot of zero-length lines in your list. Those cannot be offset. The rest seems to work, even if the components light up red.

Permalink Reply by qiushi on April 20, 2014 at 12:32pm

yes!

Thanks!

it took me almost one hour to fix that!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service