Grasshopper

algorithmic modeling for Rhino

'Offset on Srf' strange behaviour

I've noticed that the component for offsetting a curve on a surface seems to just use the Rhino command line, which makes it rather slow, and interferes with using it in a definition where the distance needs to be adjusted interactively, such as here.

Views: 823

Replies to This Discussion

Permalink Reply by Lucas Epp on January 13, 2015 at 12:37pm

Hi David,

Any ideas on how to improve the performance of the Offset Curve on Surface component?  I am using this extensively for a project and for say performing 65 offsets it takes around 14 seconds which prohibits any interactive playing with the form.

I'm wondering if a) the tolerance of the component could be relaxed greatly in circumstances like this to enable closer to real-time calculation, and b) if this could be internalized to GH so as not to use the Rhino command line.

Thanks!

Lucas

Permalink Reply by asaf yaacobi on April 24, 2016 at 6:04am

im still searching a component that does "offset curve on surface" ... any solutions since 2013?

A

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service