Grasshopper

algorithmic modeling for Rhino

Offset on rotating surface

Hi,

I have a panel consisting of individual rotating blocks. What I want to do is create depth to these blocks by offsetting inside the culled lines (which will then be extruded later on). When I attempted to do this, it worked fairly well on most of the blocks. However, there are some which didn't work as well and offsetted outside the culled lines instead. I'm guessing this is because of the plane and how its been rotated. My question is, how do I offset inside all the blocks? 

Views: 545

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on April 22, 2016 at 11:16am

Hi.

Test curve planarity and using individual curve plane would help. Best.

Attachments:
Permalink Reply by Jay on April 22, 2016 at 4:58pm

Exactly what I was looking for, thanks so much for your help! 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service