Grasshopper

algorithmic modeling for Rhino

offset curve on surface errors

Dear All,

I posted this problem a while back and have spent a week or so trying to fix it, but to no avail - I am trying to get the two outer edge curves to offset along the surface. I have tried rebuilding all the curves, I have tried rebuilding the surface. I've also tried the same in Rhino but I simply get 'curve failed to offset'. I'm pulling my hair out trying to find a way to get two simple curves to offset! does anyone have any ideas? Many thanks in advance!

Views: 1530

Attachments:

Replies to This Discussion

Permalink Reply by J-P on April 29, 2014 at 4:44pm

Its not technical, but a scale from the mid point moves them outward in the right direction, not necessarily as uniformly as offset, but its in the right direction. 

Attachments:
Permalink Reply by Tash Tash on May 4, 2014 at 6:12am

thanks very much for your reply, it's much appreciated!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service