Offset Curve bug

Hello,

I'm using the latest version of grasshopper (0.8.0010). I've read about the problems of offset curve and I'd like to share this with everyone to see if there are any suggestions to fix it. The short yellow curves are the ones that don't offset properly. Thank you very much in advance.

Yagiz

Attachments:

offsetbugdetected.jpg, 262 KB

Replies to This Discussion

Permalink Reply by kleerkoat on May 25, 2011 at 10:40am

have you tried moving the crv start point or seam?

Permalink Reply by akif yagiz saraclar on May 26, 2011 at 12:18am

A slight change fixes it. thanks for the advice.:) there is still a bug though.

Cheers,

Yagiz

Permalink Reply by akif yagiz saraclar on May 26, 2011 at 12:25am

When I make a slight change, it fixes the problem at that particular curve but creates another one at a different curve (which are sections of a surface). Well of course I fixed it by playing around with the whole thing for a while.

RSS