OFFSET CRUCE ON SURFACE

Replies to This Discussion

Permalink Reply by Jesus Galvez on March 4, 2013 at 9:19am

A quick and dirty way is [Pull Curve]. If you want to do it right, I think it might involve scaling each face, extracting the lines from the scale faces (only the ones relevant) and joining them... easier said than done. 

Attachments:

• fabricoffset_edit.gh, 4 KB

Permalink Reply by Mu_ on March 4, 2013 at 9:45pm

Thanks, but the scaling will also move the parts at the corners out of the surface!