offset command

Replies to This Discussion

Permalink Reply by Danny Boyes on July 10, 2013 at 5:47am

Hi Hadi,

[Offset] will offset a curve by this method.

Do you actually want the lines perpendicular to your curve as in the image?

Also note that this is not really a FAQ and should be placed in the Discussions forum to prevent the essential questions being found. You can edit the location via the OPTIONS button at the top of your original post.

Permalink Reply by hm on July 11, 2013 at 6:45am

i am using Extrude command, but using Unit Z, Unit X or Unit Y all can not extrude the lines perpendicular to the curve surface i want. any help?

Attachments:

• Document1.pdf, 483 KB