Grasshopper

algorithmic modeling for Rhino

offset

Hello

I am traying to offeset the edges of a box´s faces. The problem is that for some faces positive is bigger and for other it is smaller. I would apreciate if someone can help. Thanks a lot I attach the file

Views: 183

Attachments:

Replies to This Discussion

Permalink Reply by Tim Chen on August 8, 2017 at 10:18pm

I think it's because the normal of the surfaces control the direction of the offset. Though for some reason "offset loose" does the trick.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service