Non uniform surface division

Hi there,

I am trying to divide up a surface in an uneven manner. I have managed to do this in a 2d level but I would like to do this on a surface now, is this possible? Am I either able to transpose these points onto the surfaces UV grid or alter that grid so that the spacings between the U and V lines are non-uniform?

Thanks

Matt

Attachments:

Capture.JPG, 56 KB

Replies to This Discussion

Permalink Reply by Michael Pryor on September 14, 2012 at 9:47pm

http://www.grasshopper3d.com/page/search-results?cx=007664031582976...

Permalink Reply by Matthew McFetridge on September 14, 2012 at 9:51pm

Thanks for that Michael, I found this before and it's exactly what I want but it doesn't work in 0.90010 GH, and when I run it in 0.8004 it works fine. Is there a way to translate this to a newer version? Replacing the old components didn't work for me at least.

http://www.co-de-it.com/wordpress/code/grasshopper-code

Uneven subdivision one

RSS