No preview in rhino window but bakes ok

Hi everyone,

On loading grasshopper I get this error message in the rhino command line:

Message: Could not load type 'Grasshopper.Kernel.IGH_RCP_Aware' from assembly 'Grasshopper, Version=1.0.0.20, Culture=neutral, PublicKeyToken=dda4f5ec2cd80803'.

Everything works fine but there is no preview in rhino. If I bake geometry it appears though. This happened after I increased spring stiffness in kangaroo, and suddenly everything disappeared. Have done full reinstall of grasshopper but still happens.

Any ideas?

Thanks

Jack

Replies to This Discussion

Permalink Reply by David Rutten on July 21, 2014 at 12:57pm

Can you post a screenshot of the Grasshopper window and the Rhino viewport?

David Rutten

david@mcneel.com

Permalink Reply by Jack munro on July 23, 2014 at 1:59pm

Hi David,

The problem has actually resolved itself. I opened a new rhino file, as opposed to the one I was working in when the error occurred, and everything just went back to normal. It must have been something within the rhino file that was corrupted?

As far as the error message goes, Jon got in touch and thinks it might be coming from an old geometry gym installation. Haven't had a clear out yet but hopefully that will sort it.

Thanks!

RSS