Grasshopper

algorithmic modeling for Rhino

Negative Air Pressure to Shrink Wrap?

Hi,

I'm trying to use negative value of pressure to shrink wrap objects. The negative pressure value is making the mesh suck in, however the objects (which are set up to a collide mesh) are not seeming to stop the mesh from moving around them.

Could anyone take a look?

Views: 395

Attachments:

Replies to This Discussion

Permalink Reply by Mohamed Naeim on May 27, 2016 at 5:38am

Does this work for you?  

below without collide 

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service