Grasshopper

algorithmic modeling for Rhino

Need Help Cull Nth dosen't work

Hello,

i need your help,  i created some lines out of intersections. 

After that i extract the end points, now i am trying to show every second start point with a cull operation, but it dosen't work. I dont know why.

Hope someone can help.

Views: 271

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Chapulin Colorado on July 3, 2017 at 4:15pm

maybe faltten the L-inuput?

Permalink Reply by Andy P on July 3, 2017 at 4:29pm

Yes, that's the problem. Don't know why, but it works!

Thx

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service