Moving wall

Hi,

My goal is to make a moving wall with grasshopper and rhino. I made the wall by a loft option. The problem is that the segments in de wall have to move like the segments in de next video:

https://www.youtube.com/watch?v=rAn4ldWjw2w

They have to be independent horizontally and they have to move vertically. Can you help me with that? Because grasshopper makes a copy of the line that should move and I need the originally line to move vertically.

Thanks in advance

Replies to This Discussion

Permalink Reply by Laila on January 5, 2012 at 8:00am

These are the files that supposed to be with this message

Attachments:

HELP.jpg, 267 KB
HELP 1.jpg, 184 KB

Permalink Reply by lucas cañada on January 6, 2012 at 3:49pm

See this deffinition. Hope helps ;)

Attachments:

movingwall.gh, 16 KB

Permalink Reply by Laila on January 6, 2012 at 6:06pm

Hey Lucas! Thank you!! The only problem with this one it also has 2 have segments horizontally and it has 2 open. I have 2 make 2 surfaces that move from each so there will be a hole like in the video.

Attachments:

help 3.jpg, 208 KB
wand opzet 2.ghx, 1.1 MB
Help 3b.jpg, 76 KB

Permalink Reply by lucas cañada on January 7, 2012 at 4:27am

yesterday i didnt remember where i saw this deff. but now..

http://explodebreps.wordpress.com/author/gennifermunoz/

Thanks!!

Permalink Reply by Laila on January 6, 2012 at 6:10pm

I tried it again to do it on an other way, to build the wall. The only thing I still have 2 do there is that the upper segment moves up and the under segment moves down. In that way there will be a hole in between like the video. I hope you can help me Lucas... xoxo

Permalink Reply by lucas cañada on January 7, 2012 at 5:25am

hi, i think here is what you need! ;)

Attachments:

movingwall_1.gh, 30 KB

Permalink Reply by lucas cañada on January 7, 2012 at 5:27am

and rhino file

Attachments:

movingwall.3dm, 54 KB

Permalink Reply by Laila on January 7, 2012 at 6:09am

Hi! Thank you !! That is the function that I need, but I need it in the other file the that I send to you last time I replied. I am going to send it to you right now again. If you can put the function from moving up and the other down in this file then it will be perfect!! I hope I'm not asking for to much. Gr

Permalink Reply by Laila on January 7, 2012 at 6:11am

These are the files I need the moving function in. The segments now just move independently from each other. That is good but i need them to move independently from each other like the file you just made.

Attachments: