Grasshopper

algorithmic modeling for Rhino

Moving an object parallel to a Pframe

Hi. I'd like to take an object and move it to an x/y coordinate relative to the Pframe origin. I've tried several approaches and searched the forum but all discussions seem to involve placing/rotating an object on a Pframe, while keeping it centered on 0,0,0. Any suggestions? Thanks. 

Views: 605

Replies to This Discussion

Permalink Reply by David Rutten on April 16, 2014 at 4:01pm

You can create a point at the desired location using [Point Oriented]. Then construct a vector from where your geometry is now to that point using [Vector 2Pt]. Ultimately, move your geometry along this vector.

--

David Rutten

david@mcneel.com

Permalink Reply by Ethan Gross on April 16, 2014 at 4:39pm

Thank you David, perfect! Another component in my arsenal.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service