Grasshopper

algorithmic modeling for Rhino

Move point from LLX on line/curve

Hello,

how can i move a point on a Line/Curve. I think it has to be simple, i tryed Move, slider, addition.... but it dosent works.

When i have the Crv as T input the point moves on the line, but i cant controll the length. 

I dont know what i do :D 

Views: 519

Replies to This Discussion

Permalink Reply by Julian Buhagiar on August 5, 2017 at 4:55pm
Ah.... The T input is expecting a vector....because your curve is a line, GH is converting the line to a vector, if you use vector>amplitude this will control the amount it moves.

E.g crv connects to the v [assuming its a straight line], and a slider can connect to A on the amplitude component....the vector out van then go into the move component.
Permalink Reply by Andy P on August 5, 2017 at 5:11pm

Perfect, thanks :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service