Move a Control Point in Z Axis to Reshape Curve and effect Adjacent Curve Control Points

Replies to This Discussion

Permalink Reply by mark zirinsky on August 8, 2017 at 5:44pm

link a number slider, to create a Z unit vector, use 'controlpoint" (CP) to get curve control points, then to a 'move' component, then to 'nurbs' to recreate your curve with moved points

Permalink Reply by Joseph Oster on August 8, 2017 at 7:43pm

Attachments:

• MoveCP_2017Aug8a.gh, 12 KB

Permalink Reply by craig douglas on August 8, 2017 at 7:56pm

nice one jospeh, thanks much ... my next question is, can I effect control points on adjacent curves at the same time?

thanks much

c

Permalink Reply by Joseph Oster on August 8, 2017 at 8:14pm

Just add more controls, which creates more branches, more objects, etc.

Attachments:

• MoveCP_2017Aug8b.gh, 15 KB

Permalink Reply by craig douglas on August 9, 2017 at 6:02am

cool, however what happens on one curve has no effect on the adjacent curve, is there a way to effect the cps on the neighbouring curves?

thanks much

Permalink Reply by Joseph Oster on August 9, 2017 at 6:25am

There are ways to do almost anything.  What can you do?