Morphocode cellular automaton ' grid on surface/hill

hi , i'm new to grasshopper ,I'm working on my graduation project , villas and resorts on a hill located in Damascus' country side , i' m planning to use cellular automaton as a method for urban planning and architectural design , using MORPHOCODErabbit ca2dlifeconway, i spent 4 days trying to put the CA grid on a specifc surface (the hill / imported from skp) , i've posted the same quistion in morphocode page but they didn't reply . can any one help me please,i'll be grateful , thanks in advance

Replies to This Discussion

Permalink Reply by Marios Tsiliakos on November 14, 2012 at 2:29pm

Hi,
Please move this post to the general discussions, as the teachers forum is not the right place for this thread. Or even better post dirrectly to Rabbit's group so that you can get some direct help from the guys that actually built the add-on!
Best,
M.

Edit: oops, i totally missed the part where you said that you posted at the group's page!!

Permalink Reply by Kaz on November 14, 2012 at 3:08pm

you got it Marios , would you tag some who could help ,thank you man

Permalink Reply by Marios Tsiliakos on November 15, 2012 at 4:18am

hey,

Unfortunately I have no clue on how rabbit operates. When I find some time, I'll give it a try an d maybe be able to help you out. As for others who can help,can't remember a specific threat Sorry about that.

Permalink Reply by Kaz on November 15, 2012 at 9:22pm

Thank you Marios

RSS