Morph from source grid to target boundary curve

Replies to This Discussion

Permalink Reply by Marcelo Arguello on December 8, 2016 at 11:35am

Here is what i want, but do it with triangles,

i want to fit hexagons.

Permalink Reply by Laurent DELRIEU on December 8, 2016 at 2:08pm

Hello,

here is a solution which cut a curve in 4 curves, these curves are used to make a surface (with 4 sides; like a rectangle). I use uv position on this surface to map your polygon or whaterver curve you want. You can select the beginning of the cut of the curve with a slider. And then the espacement between cuts. I ude slider from Genepool, but there is another solution with graph mapper.

Attachments:

• Canvas at 21;54;42.png, 325 KB

Permalink Reply by Laurent DELRIEU on December 8, 2016 at 2:40pm

Here a more general script with point deform. So it is not limited to polylines. 

Attachments:

• Morphgridtotargetboundary_LD2.gh, 47 KB

Permalink Reply by Marcelo Arguello on December 9, 2016 at 10:52am

Great Thanks Laurent, it is that i want.

Greetings