Morph error

Replies to This Discussion

Permalink Reply by Red Hxh on November 12, 2011 at 1:00pm

You have just to replace the last 2 SBox with BBox

Permalink Reply by Natasa on November 13, 2011 at 8:45am

Thanks a lot for being so helpful :)

Permalink Reply by laeti on October 1, 2013 at 9:07am

Hello,

I also gave a try on the turning torso :p   but the outcome is different from the one expected (blue).

Could someone give a hint on the mistakes ?

thank you in advance,

ps:

the slabs are done with the VisualArq slab component

Attachments:

• GH-turningTorso-trial-1.gh, 37 KB
• GH-turningTorso-2.png, 323 KB
• GH-turningTorso-3.png, 286 KB

Permalink Reply by David Rutten on October 1, 2013 at 12:26pm

The lines inside the X input of the Rotate component are different. That would explain why they do not generate the same result. Or did I miss the problem-area?

--

David Rutten

david@mcneel.com

Tirol, Austria