Grasshopper

algorithmic modeling for Rhino

Modular Panelling

Hi all, 

I have encountered a problem in creating a paneling system for a fluid form.

I understand the principles of creating a paneling system, but was wondering if there was a method to create a modular panel system; which would use approximately 2-3 variations to create a complex form.  

At the moment I am experimenting with kangaroo and relaxing the mesh to get the a mesh with the same size and shape.

Something very similar to this but with a more orthogonal pattern:

http://www.grasshopper3d.com/video/equilateralization-1?xg_source=a...

Any other suggestions??

Thanks for any comments or help.

Views: 1632

Replies to This Discussion

Permalink Reply by Hugo Tavares on January 2, 2012 at 8:37pm

Having the same problem.

Permalink Reply by zj D. Wong on January 9, 2012 at 7:41pm

anyone with any ideass??

any would be appreciated :)

Permalink Reply by Zayad Motlib on January 9, 2012 at 9:59pm

Been having similar challenge for a while ....

Permalink Reply by Kieran on September 3, 2012 at 10:22pm

Anybody solutions? I am also having this problem.

Permalink Reply by amir shahrad on January 29, 2013 at 7:50am

i have same problem whit my head in office :(

Permalink Reply by Michael Pryor on January 29, 2013 at 8:45am

Show some sketch or start some definition of your idea then it will be easier to help I think.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service