Modifying cube geometry

Hi, I'm very new to Grasshopper and I need some help to get started.

I'm trying to create a cube and modify its geometry by changing each corner length between min and max values, and having as a limitation a maximun angle between corners.

Is it possilble? Any advice about it?

Thanks a lot!

Edited: Where I said corner I meant edge.

Replies to This Discussion

Permalink Reply by Danny Boyes on October 28, 2013 at 5:20am

Here are a couple of ideas to get you started

Components used:

Sliders, Min, Max, Vector XYZ, Amplitude, Line SDL, Rotate, Move, Box2Pt

Attachments:

MinMaxExample.gh, 29 KB

Permalink Reply by Octavio Hombrados on October 28, 2013 at 5:39am

Thanks a lot Danny Boyes. I'm afraid when I said 'corner' I meant 'edge'. The thing is I want to transform the cube into a irregular polyhedron by modifiying each edge length.

Sorry for my mistake, and your model is a good start point for me to begin understanding things.

Thanks again!!!

RSS