minimal surface

hello to everybody,

I will ask you how I can made a surface between curves in my project.

I tried different methods, for example I used the addon minimal surface loft,without progress.

I hope that you can help me

Attachments:

project.jpg, 222 KB
project 2.jpg, 194 KB

Replies to This Discussion

Permalink Reply by Daniel González Abalde on December 9, 2014 at 3:28pm

Why does not work for you the minimal surface addon? Perhaps the problem is the seam and direction of your curves.

Permalink Reply by Valentin on December 9, 2014 at 3:54pm

Hi gasterx,

Where can I get or download this addon?

Permalink Reply by peter fotiadis on December 10, 2014 at 3:13am

http://www.cerver.org/downloads/

BTW: I would rather suggest to dig-in into Kangaroo as well for that min surf matter. Notify if you need some "simple" (*) examples that use both ways.

(*) kinda, he he.

best, Peter

Permalink Reply by peter fotiadis on December 10, 2014 at 3:37am

BTW: Plan B: minsurf VS Kangaroo. See 212_xxx attached (very old case that one almost prehistoric, I don't use GH components any more these days)

BTW: Plan C: you can use Starling as well (not apples to apples VS Kangaroo, but good in quite a few cases). See MinSurf_xxx attached (use Rhino file if data internalization fails, happens in most of cases).

Attachments: