Grasshopper

algorithmic modeling for Rhino

min & max on grafted list

The top definition has 3 points, with 3 different distance components to make 3 independent lists, which I can then plug into extremes to get a new list based on minimums and maximums.

however, the bottom definition has the 3 points all referenced into one point component (more convenient for a lot of points)and is grafted, then is using one distance component with the sq grid points, essentially creating the same 3 lists as the other definition due to list matching ( the beauty of GH), but they themselves live in a list.

my question is how can i then obtain a new minimum or max value list from those 3 lists without using explode tree and then plugging into extremes. Is there a method or component that can detect multiple lists being plugged into one input and then output a new min or max list. if not could there be one in the future? Thanks.

Views: 6052

Replies to This Discussion

Permalink Reply by Hannes Löschke on April 1, 2012 at 1:42pm

Okay, here's my two FlipMatrix vs. your three Flatten... :)

Permalink Reply by Michael Pryor on April 1, 2012 at 3:29pm

You and Tudor are great Thanks a lot guys. 

Permalink Reply by Michael Pryor on April 3, 2012 at 1:05pm

Finally had a chance to look at this (and think about it when its not 3am :p) and I also found a way to do it. Figured I would share.

Permalink Reply by Michael Pryor on May 5, 2012 at 6:37pm

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service