Grasshopper

algorithmic modeling for Rhino

Millipede Plug-in problem

Hi everybody!!

I have just downloaded and installed millipede but it doesn´t work. I am using Rhino5 64 and grasshopper 0.9.0061. When I start grasshopper, the program seems to load millipede, but when it is open, I cannot see the millipede plug-in.

Any idea?

Thank you in advance.

Views: 1679

Replies to This Discussion

Permalink Reply by Michael Pryor on November 14, 2013 at 9:08am

You need to right click each file, properties, unblock.

http://www.grasshopper3d.com/group/millipede/forum/topics/rhino-5-m...

Permalink Reply by Jose M. Ortolano on November 15, 2013 at 12:17am

Thank you Michael,

it worked properly!!!!

Regards.

Permalink Reply by Jesper Hildebrandt Andersen on December 6, 2013 at 12:45pm

Okey, what a funny small thing. But i still can get the FE milipide to work. :(

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service