Grasshopper

algorithmic modeling for Rhino

meshContourNotWorking

Hello everybody !

I have a problem, i've trying to make contour on the mesh into the rhino file every 100 mm and it's not working, i don't understand why ? If someone can check the file it'll be very nice... thanks in advance for your help.

Nenov ivo

Views: 259

Attachments:

Replies to This Discussion

Permalink Reply by djordje on April 18, 2015 at 11:07am

Hi Ivo,

Your mesh is smaller than 100 millimeters threshold: 59mm in width, and 86mm in length.

So either scale the initial mesh, or decrease the size of the contour distance.

Check the attached file.

Attachments:
Permalink Reply by Nenov Ivo on April 19, 2015 at 11:42am

Thank you Djordje, I completely forget to check the scale of my drawing. Thanks again.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service