Mesh to Surface

Replies to This Discussion

Permalink Reply by Nik Willmore on June 24, 2015 at 7:48pm

Consider initial remeshing if the input is too complex, using MeshMachine of Kangaroo. Your solution is essentially the same as what I came up with too, there being a thread or two here that uses often much more complicated solutions.

To solve a problem though can require looking at the assumptions involved which isn't possible without an upload of the actual meshes you are working with.

My search for "abaixao code" was not fruitful.

Permalink Reply by Nik Willmore on June 28, 2015 at 10:54am

Here is a new post about mesh to NURBS:
http://www.grasshopper3d.com/forum/topics/how-to-voronoi-the-bunny