Grasshopper

algorithmic modeling for Rhino

mesh splitting/trimming

hi there,

i do have a triangulated mesh stripe, in top view  its a rectangle.

how can i split the stripe with multiple planes and getting the different elements

i tried MESHSPLIT PLANE but gives not single elements but pairs of elements.

thanxs !

Views: 1884

Replies to This Discussion

Permalink Reply by djordje on April 20, 2013 at 11:07am

Wasn't that the point - you have a mesh and by splitting it with a vertical plane it gets halved - into one half and another?

Permalink Reply by pyrit on April 20, 2013 at 12:28pm

hi djordje,

im aiming for 5 independent meshes (as shown in the pic)

thank you

Permalink Reply by ian bake on April 21, 2013 at 8:34pm

hi pyrit. I hope this helps. By using a curve to split into multiple planes before splitting it then selecting it again after the split. 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service