Grasshopper

algorithmic modeling for Rhino

mesh relaxing with kangaroo

Hi

i want to control the minimum height of this mesh surface ("H" in the right view) and the depth of the "A" curve ("A" in top view). actually i want to increase the "H" and decrease the depth of the "A" curve. when i Increase the stiffness of the "A" curve (The edge of "A" curve) more than 5500, the mesh becomes wrong (picture below).

And when i decrease the stiffness of Crv1 And Crv2, it helps to decrease the depth of "A" curve but it causes to decrease the height ("H").

Thanks For Your Help.

I genuinely apologise for my terrible English. :D

Views: 7577

Attachments:

Replies to This Discussion

Permalink Reply by Mahdiyar on June 2, 2012 at 6:48am

Thank you and sorry for the misunderstanding.

Permalink Reply by Mahdiyar on June 2, 2012 at 6:46am

The structure system that i want to modeling is a tent (tensile) structure.

(tent systems with two central arches for high point construction)

as you can see the curve depth should decrease and the height should increase.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service