Grasshopper

algorithmic modeling for Rhino

MESH PROBLEMS

I am trying to build a new face with mesh triangle component using two existing points and a new one BUT no luck .... What am I missing ???

Views: 341

Replies to This Discussion

Permalink Reply by Hannes Löschke on March 26, 2013 at 3:46pm

A face is no geometry. Its just a set of 3 or four numbers indicating the vertices that should form a triangle or quad in the mesh. So in order to see any geometry, you need to build the mesh from a list of vertices and faces (mesh component "Create a mesh from scratch").

Permalink Reply by pantelis apostolou on March 27, 2013 at 3:54am

Thank you Hannes .. I ll try that

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service